UMTS Inter Vendor Hard Handover Issue Analysis

Hard handover could be an issue if two or more vendors are involved. Following steps can be taken to identify and kill the problem:

1. Neighbor configuration verification (LAC/RAC)
1. Definitions in both source and target RNC
2. Core network (MSC) definitions
2. Parameters check related to Hard Handver
1. Switch (Some vendors have Hard Handover Switch)
2. Threshold settings (could be too tight to initiate Handover)

A solved case scenario:

Ericsson to ZTE hard handovers were not taking place (there were no attempts at all). 

• Neighbors were correctly defined at both RNCs
• Core definitions were verified as well
• RNC trace analysis showed relocation failure message from MSC to RNC with eRANAP cause as "misc_unspecified_failure"

Source RNC Trace log

Core/MSC trace showed that relocation_request was being forwarded by the MSC to target RNC when relocation_required message is sent by source RNC. However, when target RNC did not respond with relocation_request_ack, the MSC sent the relocation_preparation_failure with "unspecified failure". This showed that target RNC (Ericsson) had some functional issue. On further investigation, it was found that Ericsson RNC had a switch parameter for hard handover which was disabled. Enabling it rectified the problem and hard handovers began to take place.

Mobile Originating Call Flow

Here is the detailed Mobile Originating Call Flow divided into 4 functional modules depicting the network nodes for easy comprehension:

High SDCCH Blocking Statistical Analysis

SDCCH Blocking is a critical KPI that depicts the quality of optimization in a network as this KPI is mostlty controlled via soft optimization. The considerations for maintaining this KPI are as follows:

1. SDCCH/TCH Availability %
1. Many times, the SDCCH traffic is enough to be carried in defined channels, but still the blocking is high. This could be mostly due to momentary surge in traffic or site fluctutation causing blocks for a small portion of an hour, thereby averaging the traffic/availability in the hour.
2. SDCCH Drops
1. TA Analysis
2. Interference (Co/Adjacent)
3. TCH Congestion
4. Equipment Failure
5. Low output power
3. SDCCH Channels/Traffic/Blocking (Erlang Table)
1. SDCCH Addition (Static/Dynamic)
2. SDCCH/TCH Conversion Timer
3. Maximum SDCCH Channels Threshold
4. Penalty Timer (Set PT = 31 of cell)
5. Increase CRH (Cell Reselect Hysteresis) if cell is on LAC Boundary
6. Directed Retry (Forced)

Major KPIs

The major KPIs that need to be monitored on daily basis on BSC/Cell/TRX level in a network are:

1. DCR  % (Dropped Call Rate)
2. HOSR % (Handover Success Rate)
3. TCH Blocking %
4. SDCCH Blocking %
5. TRX Efficiency % (TCH Seizures/TCH Call Attempts X 100)
6. IBI % (Band 4+5)